Adjust spring tension rod
wider than your door opening and insert into one of the two
tunnels at the top of the screen. You enlarge the spring
tension rod by unscrewing the smaller end counter clockwise.
2-
Put one side of the
tension rod in top corner of your doorjamb and slide the
other side up.
3-
Adhere Velcro adhesive
strips (sewn onto the screen) to sides of your doorjamb.
After the installation, check to make sure the rod is tight
in the doorjamb. If not, open the rod a little wider. The
center opening of the screen should be centered in the
doorjamb. Adjust the screen mesh towards the center of the
rod. That's all there is to it! Now Bug Off can be removed
and replaced in minutes.
.jpg)
.jpg)
.jpg)
