Install locakable Cat Flap

• Ideal Cat Flap

Simple 6-Step Installation 
Letters in ( ) correlate to diagram above:

Step #1:        Determine pet door height. The distance between bottom of door and bottom of
                       template should be 6". Center template (width) in middle of door and tape in place.

Step #2:        With template in place (A), draw around edge of template onto door. Mark corner
                       holes with a nail or awl.

Step #3:        Using corner locations as your guide, drill four individual holes, using a drill no larger
                       than 1/2".

Step #4:        Starting on the inside of one of the drilled holes (B), cut just inside of the line using a
                       key-hole or scroll saw.

Step #5:        Insert inner frame (C) (with flap) into the opening from interior side (inside and outside
                      frames have been clearly marked for easier assembly). Make certain frame is flush with
                      door surface. Caulking is recommended under outer frame. Place outer frame (D)
                      (no flap) into opening from outside door, hold in place, then install screws and tighten
                      until snug. Do not over-tighten.

Step #6:        To use the Four-Way Lock, see instructions on Cat Flap frame.

Uneven surfaced doors: 
After cutting the rough opening, build up the lowest areas
with wood frame thick enough to create an even door surface.

The Cat Flap can be installed in walls, steel doors, and storm doors. 
Note that additional materials, such as wood framing, plaster, touch-up paint, 
longer frame screws, and extra tools may be required.


Walls:
Once wall opening has been made, it will be necessary 
to build a frame to cover the exposed area between wall surfaces.
 Use wood screws to attach interior and exterior frame to wall surfaces. 
When cutting through walls, extreme caution must be used to not cut any 
concealed electrical wires, gas lines, or water pipes.


Steel doors: 
Use a jigsaw with a hacksaw blade to cut the opening, starting at pre-drilled corner holes.